Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Pt
Al
Ota, Kyugo*; Watabe, Yuki*; Haga, Yoshinori; Iesari, F.*; Okajima, Toshihiko*; Matsumoto, Yuji*
Symmetry (Internet), 15(8), p.1488_1 - 1488_13, 2023/07
Times Cited Count：1 Percentile：66.09(Multidisciplinary Sciences)
X-ray synchrotron diffractionLi, H.*; Liu, Y.*; Zhao, W.*; Liu, B.*; Tominaga, Aki; Shobu, Takahisa; Wei, D.*
International Journal of Plasticity, 165, p.103612_1 - 103612_20, 2023/06
Times Cited Count：2 Percentile：78.7(Engineering, Mechanical)In order to clarify the strength properties of Co-free maraging steel, tensile experiment using high energy synchrotron X-ray diffraction was performed. Diffraction profiles from the martensitic and austenitic phases were obtained, and their strength and width were observed to vary as loading. Analysis of the diffraction profiles showed that the content of martensite in the as-aged material decreased slowly at low stress levels and decreased rapidly at high stress levels. On the other hand, the austenite phase in the as-solution materials was significantly transformed the martensite phase as the stress increased. It was clarified to be responsible for their respective strength properties.
Yamazaki, Yasuhiro*; Shinomiya, Keisuke*; Okumura, Tadaharu*; Suzuki, Kenji*; Shobu, Takahisa; Nakamura, Yuiga*
Quantum Beam Science (Internet), 7(2), p.14_1 - 14_12, 2023/05
} polyoxo cluster UO
Cl
(MeO)
(x = 2.3, MeO = methoxide)Fichter, S.*; Radoske, T.*; Ikeda, Atsushi
Acta Crystallographica Section E; Crystallographic Communications (Internet), 77(8), p.847 - 852, 2021/08
Inami, Toshiya*; Shobu, Takahisa; Ishii, Kenji*
IEEE Transactions on Magnetics, 57(3, Part 2), p.6400105_1 - 6400105_5, 2021/03
Times Cited Count：0 Percentile：0(Engineering, Electrical & Electronic)Yoshida, Koji*; Inoue, Takuya*; Torigoe, Motokatsu*; Yamada, Takeshi*; Shibata, Kaoru; Yamaguchi, Toshio*
Journal of Chemical Physics, 149(12), p.124502_1 - 124502_10, 2018/09
Times Cited Count：4 Percentile：17.83(Chemistry, Physical)Differential scanning calorimetry, X-ray diffraction, and quasi-elastic neutron scattering (QENS) measurements of aqueous glycine solutions confined in mesoporous silica (MCM-41) were performed at different glycine concentrations, pH, and loading ratio (= mass of glycine solution / mass of dry MCM-41) in the temperature range from 305 to 180 K to discuss the confinement effect on the thermal behavior, the structure, and the dynamic properties of the solutions.
Oka, Hiroshi; Tanno, Takashi; Otsuka, Satoshi; Yano, Yasuhide; Kaito, Takeji
Nuclear Materials and Energy (Internet), 16, p.230 - 237, 2018/08
Times Cited Count：4 Percentile：38.58(Nuclear Science & Technology)
observation of dislocation evolution in ferritic and austenitic stainless steels under tensile deformation by using neutron diffractionSato, Shigeo*; Kuroda, Asumi*; Sato, Kozue*; Kumagai, Masayoshi*; Harjo, S.; Tomota, Yo*; Saito, Yoichi*; Todoroki, Hidekazu*; Onuki, Yusuke*; Suzuki, Shigeru*
Tetsu To Hagane, 104(4), p.201 - 207, 2018/00
Times Cited Count：9 Percentile：44.29(Metallurgy & Metallurgical Engineering)Toyokawa, Hidenori*; Saji, Choji*; Kawase, Morihiro*; Wu, S.*; Hurukawa, Yukihito*; Kajiwara, Kentaro*; Sato, Masugu*; Hirono, Toko*; Shiro, Ayumi*; Shobu, Takahisa; et al.
Journal of Instrumentation (Internet), 12(1), p.C01044_1 - C01044_7, 2017/01
Times Cited Count：4 Percentile：21.22(Instruments & Instrumentation)We have been developing CdTe pixel detectors combined with a Schottky diode sensor and photon-counting ASICs. The hybrid pixel detector was designed with a pixel size of 200 micro-meter by 200 micro-meter and an area of 19 mm by 20 mm or 38.2 mm by 40.2 mm. The photon-counting ASIC, SP8-04F10K, has a preamplifier, a shaper, 3-level window-type discriminators and a 24-bits counter in each pixel. The single-chip detector with 100 by 95 pixels successfully operated with a photon-counting mode selecting X-ray energy with the window comparator and stable operation was realized at 20
C. We have performed a feasibility study for a white X-ray microbeam experiment. Laue diffraction patterns were measured during the scan of the irradiated position in a silicon steel sample. The grain boundaries were identified by using the differentials between adjacent images at each position.
Oka, Hiroshi; Tanno, Takashi; Otsuka, Satoshi; Yano, Yasuhide; Uwaba, Tomoyuki; Kaito, Takeji; Onuma, Masato*
Nuclear Materials and Energy (Internet), 9, p.346 - 352, 2016/12
Times Cited Count：21 Percentile：88.83(Nuclear Science & Technology)Watanabe, Masashi*; Yonezawa, Toshio*; Shobu, Takahisa; Shiro, Ayumi; Shoji, Tetsuo*
Corrosion, 72(9), p.1155 - 1169, 2016/09
Times Cited Count：1 Percentile：6.28(Materials Science, Multidisciplinary)
-phase in 
-based titanium aluminide intermetallicsLiss, K.-D.*; Funakoshi, Kenichi*; Dippenaar, R. J.*; Higo, Yuji*; Shiro, Ayumi*; Reid, M.*; Suzuki, Hiroshi; Shobu, Takahisa; Akita, Koichi
Metals, 6(7), p.165_1 - 165_22, 2016/07
Times Cited Count：20 Percentile：68.21(Materials Science, Multidisciplinary)Titanium aluminides find application in modern light-weight, high-temperature turbines, such as aircraft engines, but suffer from poor plasticity during manufacturing and processing. Huge forging presses enable materials processing in the 10 GPa range and hence, it is necessary to investigate the phase-diagrams of candidate materials under these extreme conditions. Here we report on an in-situ synchrotron X-ray diffraction study in a large-volume-press of a modern (
+ ) two-phase material, Ti-45Al-7.5Nb-0.25C, under pressures up to 9.6 GPa and temperatures up to 1686 K. At room temperature, the volume response to pressure is accommodated by the transformation 
rather than volumetric strain, expressed by apparently high bulk moduli of both constituent phases. Crystallographic aspects, specifically lattice strain and atomic order are discussed in detail. It is interesting to note that this transformation takes place despite an increase in atomic volume, which is due to the high ordering energy of . Upon heating under high pressure, both the eutectoid and -solvus transition temperatures are elevated, and a third, cubic -phase is stabilized above 1350 K. Earlier research has shown that this -phase is very ductile during plastic deformation, essential in near-conventional forging processes. Here, we were able to identify an ideal processing window for near-conventional forging, while the presence of the detrimental -phase is not present under operating conditions. Novel processing routes can be defined from these findings.
FeH
; Iron-containing complex hydride with high gravimetric hydrogen densitySaito, Hiroyuki; Takagi, Shigeyuki*; Matsuo, Motoaki*; Iijima, Yuki*; Endo, Naruki*; Aoki, Katsutoshi*; Orimo, Shinichi*
APL Materials (Internet), 2(7), p.076103_1 - 076103_7, 2014/07
Times Cited Count：25 Percentile：70.44(Nanoscience & Nanotechnology)
La
B revealed by high-resolution X-ray diffractionInami, Toshiya; Michimura, Shinji*; Hayashi, Yuya*; Matsumura, Takeshi*; Sera, Masafumi*; Iga, Fumitoshi*
Physical Review B, 90(4), p.041108_1 - 041108_5, 2014/07
Times Cited Count：9 Percentile：38.87(Materials Science, Multidisciplinary)We carried out a high-resolution X-ray diffraction experiment on CeLaB. This compound exhibits antiferro-octupole order (AFO) below 
= 1.4 K, and it is theoretically suggested that ferroquadrupole moments and a resultant rhombohedral deformation are induced in the AFO phase. We observe the splitting of Bragg reflections below and find that the unit cell is rhombohedral with the elongated [111] axis. We also precisely evaluate the magnitude of the induced quadrupole moments from the obtained shear strain and find that the quadrupole moments are not reduced in the AFO phase.
LaB studied by resonant X-ray diffractionMatsumura, Takeshi*; Michimura, Shinji*; Inami, Toshiya; Otsubo, Toru*; Tanida, Hiroshi*; Iga, Fumitoshi*; Sera, Masafumi*
JPS Conference Proceedings (Internet), 3, p.014008_1 - 014008_6, 2014/06
We study the 
-type antiferro-octupole (AFO) ordered state of CeLaB below 1.5 K by resonant X-ray diffraction in magnetic fields. Multipole moments induced by the field in the AFO phase are identified. In a mean-field model for the AFO order within the 
quartet crystal-field ground state, the 
and 
antiferroquadrupoles (AFQ) are expected as mostly induced AFQ. However, in contrast to this expectation, the main induced moment is found to be the 
-type AFQ.
Fukuda, Yuji; Yamakawa, Koichi
Progress in Ultrafast Intense Laser Science II, p.231 - 251, 2007/00
To better understand a fundamental aspect of the laser cluster interaction, we have carried out systematic investigations of X-ray radiation properties of high-density and high-temperature cluster plasma, created by the action of superintense laser irradiation. The interrelationship between the X-ray radiation properties and ion kinetic energies has been for the first time examined by the simultaneous measurements of X-ray radiation spectra and ion energy spectra. Time scale and mechanism of X-ray emission process have been discussed based on a time-dependent plasma kinetics model. Moreover, in order to demonstrate the practical capability of X-rays thus produced, the pulse X-ray diffraction has been examined from Si crystal with this source.
4); Comparison of X-ray diffraction and first-principles calculationTakahashi, Masamitsu; Kratzer, P.*; Penev, E.*; Mizuki, Junichiro
Surface Science, 600(18), p.4099 - 4102, 2006/09
Times Cited Count：1 Percentile：6.64(Chemistry, Physical)The GaAs(001)-c(44) has been studied by synchrotron surface X-ray diffraction. The atomic coordinates and Debye-Waller factors were determined up to the sixth layer from the surface. The results support the formation of the Ga-As heterodimers. The resultant atomic coordinates were compared with those given by a first-principle calculation. In spite of the theoretical prediction of the stability of the single-heterodimer structure, our data fit best a three-heterodimer model where three heterodimers are present in one unit cell. The preference of the formation of the three heterodimers will be discussed in the relationship with the transition process from the 24 to the c(44) structures.
Suzuki, Hiroshi
Netsu Shori, 46(1), p.11 - 18, 2006/02
no abstracts in English
thin films by ion irradiationNarumi, Kazumasa; Sakai, Seiji; Naramoto, Hiroshi*; Takanashi, Koki
JAEA-Review 2005-001, TIARA Annual Report 2004, p.238 - 240, 2006/01
no abstracts in English
films polymerized by ion irradiationNarumi, Kazumasa; Sakai, Seiji; Naramoto, Hiroshi*; Takanashi, Koki
Fullerenes, Nanotubes, and Carbon Nanostructures, 14(2-3), p.429 - 434, 2006/00
no abstracts in English
